Supported Radius Attributes; Table 64 Supported Tunnel Protocol Attribute - ZyXEL Communications GS-4012 User Manual

Intelligent layer 3+ switch
Table of Contents

Advertisement

Chapter 23 Authentication & Accounting
Table 63 Supported VSAs
FUNCTION
Egress Bandwidth
Assignment
Privilege Assignment
23.2.4.1 Tunnel Protocol Attribute
You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS
server documentation) to assign a port on the Switch to a VLAN based on IEEE 802.1x
authentication. The port VLAN settings are fixed and untagged. This will also set the port's
VID. The following table describes the values you need to configure. Note that the bolded
values in the table are fixed values as defined in RFC 3580.

Table 64 Supported Tunnel Protocol Attribute

FUNCTION
VLAN Assignment

23.3 Supported RADIUS Attributes

Remote Authentication Dial-In User Service (RADIUS) attributes are data used to define
specific authentication, and accounting elements in a user profile, which is stored on the
RADIUS server. This appendix lists the RADIUS attributes supported by the Switch.
Refer to RFC 2865 for more information about RADIUS attributes used for authentication.
Refer to RFC 2866 and RFC 2869 for RADIUS attributes used for accounting.
This appendix lists the attributes used by authentication and accounting functions on the
Switch. In cases where the attribute has a specific format associated with it, the format is
specified.
194
ATTRIBUTE
Vendor-Id = 890
Vendor-Type = 2
Vendor-data =
egress rate (Kbps in decimal format)
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
Vendor-ID = 9
(CISCO)
Vendor-Type = 1
(CISCO-AVPAIR)
Vendor-Data = "shell:priv-lvl=N"
where
N
is a privilege level (from 0 to 14).
Note: If you set the privilege level of a login account differently
on the RADIUS server(s) and the Switch, the user is
assigned a privilege level from the database (RADIUS or
local) the Switch uses first for user authentication.
ATTRIBUTE
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
Note: You must also create a VLAN with the specified VID on
the Switch.
VLAN ID
GS-4012F/4024 User's Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs-4012fGs-4024

Table of Contents