Test; Interface No Command Examples; No Bandwidth-Limit - ZyXEL Communications GS-4012 User Manual

Intelligent layer 3+ switch
Table of Contents

Advertisement

where
<auto|10-half|10-
full|100-half|100-
full|1000-full>
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the speed to 100 Mbps in half duplex mode.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# speed-duplex 100-half

48.2.14 test

You can perform an interface loopback test on specified ports. The test returns
Failed!
An example is shown next.
• Select ports 3-6 for internal loopback test.
• Execute the test command.
• View the results.
sysname(config)# interface port-channel 3-6
sysname(config-interface)# test 3-6
Testing internal loopback on port 3 :Passed!
Ethernet Port 3 Test ok.
Testing internal loopback on port 4 :Passed!
Ethernet Port 4 Test ok.
Testing internal loopback on port 5 :Passed!
Ethernet Port 5 Test ok.
Testing internal loopback on port 6 :Passed!
Ethernet Port 6 Test ok.

48.3 Interface no Command Examples

Similar to the no commands in the Enable and Config modes, the no commands for the
Interface sub mode also disable certain features. In this mode, however, this takes place on a
port by port basis.

48.3.1 no bandwidth-limit

You can disable bandwidth limit on port 1 simply by placing the
bandwidth-limit
GS-4012F/4024 User's Guide
=
Sets the duplex mode (half or full) and speed (10, 100 or 1000
Mbps) of the connection on the port. Selecting auto (auto-
negotiation) makes one port able to negotiate with a peer
automatically to obtain the connection speed and duplex mode
that both ends support.
command.
Chapter 48 Interface Commands
Passed!
command in front of the
no
or
401

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs-4012fGs-4024

Table of Contents