Table of Contents
Advertisement
12.6 Static Route Summary
Click Network > Routing > Static Route to open the Static Route screen.
Figure 149 Network > Routing > Static Route
The following table describes the labels in this screen.
Table 68 Network > Routing > Static Route
LABEL
#
Destination
Subnet Mask
Next-Hop
Metric
Add icon
12.7 Edit a Static Route
Select a static route index number and click Edit. The screen shown next appears. Use this
screen to configure the required information for a static route.
Figure 150 Network > Routing > Static Route > Edit
ZyWALL 1050 User's Guide
DESCRIPTION
This is the number of an individual static route.
This is the destination IP address.
This is the IP subnet mask.
This is the IP address of the next-hop gateway or the interface through which the
traffic is routed. The gateway is a router or switch on the same segment as your
ZyWALL's interface(s). The gateway helps forward packets to their destinations.
This is the route's priority among the ZyWALL's routes. The smaller the number, the
higher priority the route has.
Click the Add icon to go to the screen where you can set up a static route on the
ZyWALL.
Click the Edit icon to go to the screen where you can edit the static route on the
ZyWALL.
Click the Remove icon to delete an existing static route from the ZyWALL. A window
displays asking you to confirm that you want to delete the routing policy.
Chapter 12 Policy and Static Routes
229
Advertisement
Table of Contents
Troubleshooting
