Configuring Layer-2 Isolation; Figure 118 Menu 3.5.4 Bridge Link Configuration; Table 68 Menu 3.5.4 Bridge Link Configuration - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

Figure 118 Menu 3.5.4 Bridge Link Configuration

Press Space Bar to Toggle.
The following table describes the fields in this menu.

Table 68 Menu 3.5.4 Bridge Link Configuration

FIELD
Enable Link 1 ~ 5
Peer MAC Address
PSK
Enable WDS Security Select Yes to enable WDS on your ZyAIR. A Wireless Distribution System
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

17.3.5 Configuring Layer-2 Isolation

Follow the steps below to configure layer-2 isolation on your ZyAIR.
1 From the main menu, enter 3 to open Menu 3 – LAN Setup.
2 Enter 5 to display Menu 3.5 – Wireless LAN Setup.
Chapter 17 LAN Setup
Enable Link 1= Yes
PSK= ********
Enable Link 2= No
PSK= ********
Enable Link 3= Yes
PSK= ********
Enable Link 4= No
PSK= ********
Enable Link 5= Yes
PSK= ********
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Press [SPACE BAR] to select Yes or No and press [ENTER].
Type the MAC address of peer device in valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols)
(WDS) is a wireless connection between two or more APs.
When you select Yes, you are prompted to type a Pre-Shared Key (PSK) in the
PSK fields of each bridge link you want to configure. The ZyAIR uses TKIP to
encrypt traffic on the WDS between AP's.
Note: Other AP's must use the same encryption method to
enable WDS.
Menu 3.5.4 - Bridge Link Configuration
Peer MAC Address= 0b:16:21:2c:37:45
Peer MAC Address= 00:0b:16:2c:37:3d
Peer MAC Address= 0b:16:21:2c:37:3e
Peer MAC Address= 0b:16:21:2c:37:3f
Peer MAC Address= 0b:16:21:2c:37:40
Enable WDS Security= Yes
G-3000H User's Guide
189