Figure 110 Menu 3.5 Wireless Lan Setup; Table 64 Menu 3.5 Wireless Lan Setup - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

Figure 110 Menu 3.5 Wireless LAN Setup

Operating Mode= Bridge / Repeater
Hide Name (SSID)= N/A
Channel ID= CH06 2437MHz
RTS Threshold= 2432
Frag. Threshold= 2432
Press Space Bar to Toggle.
The following table describes the fields in this menu.

Table 64 Menu 3.5 Wireless LAN Setup

FIELD
Operating Mode
Name (SSID)
Hide Name (SSID)
Channel ID
RTS Threshold
Frag. Threshold
Edit MAC Address Filter Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 3.5.1 - WLAN
Edit Bridge Link
Configuration
Edit Roaming
Configuration
Chapter 17 LAN Setup
Menu 3.5 - Wireless LAN Setup
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Press [SPACE BAR] and select Access Point, Bridge / Repeater, AP + Bridge or
MESSID.
This field is not available on all models.
The SSID (Service Set IDentity) identifies the AP to which the wireless stations associate.
Wireless stations associating to the AP must have the same SSID. Enter a descriptive
name of up to 32 printable 7-bit ASCII characters.
This field is only available when you select Access Point or AP + Bridge in the Operating
Mode field.
Press [SPACE BAR] and select Yes to hide the SSID in the outgoing data frame so an
intruder cannot obtain the SSID through scanning.
Press [SPACE BAR] to select a channel. This allows you to set the operating frequency/
channel depending on your particular region.
Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value between 800
and 2432.
This is the maximum data fragment size that can be sent. Enter a value between 256 and
2432.
MAC Address Filter.
Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.4 - Bridge Link
Configuration.
Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.2 - Roaming
Configuration. This field is not available when you select Bridge / Repeater in the
Operating Mode field.
Edit MAC Address Filter= N/A
Edit Roaming Configuration= N/A
Edit SSID Profile= N/A
Select SSID Profile= N/A
Edit Bridge Link Configuration= No
Preamble= Long
802.11 Mode= Mixed
Max. Frame Burst= 650
Breathing LED= Yes
Block Intra-BSS Traffic= No
Output Power= <11b>17dBm/<11g>13dBm
Edit Layer-2 Isolation= N/A
G-3000H User's Guide
181