Configuring Management Vlan Example; Figure 55 Management Vlan Configuration Example - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

Table 34 VLAN
LABEL
Name
Apply
Reset

9.2.1 Configuring Management VLAN Example

This section shows you how to create a VLAN on an Ethernet switch.
By default, the port on the ZyAIR is a member of the management VLAN (VID 1). The
following procedure shows you how to configure a tagged VLAN.
Note: Use the out-of-band management port or console port to configure the switch if
you misconfigure the management VLAN and lock yourself out from performing
in-band management.
On an Ethernet switch, create a VLAN that has the same management VLAN ID as the
ZyAIR. The following figure has the ZyAIR connected to port 2 of the switch and your
computer connected to port 1. The management VLAN ID is ten.

Figure 55 Management VLAN Configuration Example

Perform the following steps in the switch web configurator:
1 Click VLAN under Advanced Application.
2 Click Static VLAN.
3 Select the ACTIVE check box.
4 Type a Name for the VLAN ID.
Chapter 9 VLAN
DESCRIPTION
Type a name to have the ZyAIR check for specific VLAN attributes on
incoming messages from the RADIUS server. Access-accept packets sent by
the RADIUS server contain VLAN related attributes. The configured Name
field is checked against these attributes. If the configured Name field matches
these attributes, the corresponding VLAN ID entry is used to access the
specific VLAN group. If the configured Name field does not match the VLAN
related attributes sent from the RADIUS server, a wireless station is assigned
the associated SSID VLAN ID. See VLAN ID in the SSID screen.
Click Apply to save your changes back to the ZyAIR.
Click Reset to begin configuring this screen afresh.
G-3000H User's Guide
115