Figure 25 Wireless: Bridge/Repeater; Table 15 Wireless: Bridge/Repeater - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

Figure 25 Wireless: Bridge/Repeater

The following table describes the bridge labels in this screen.

Table 15 Wireless: Bridge/Repeater

LABEL
Operating Mode
Choose Channel ID
Scan
RTS/CTS Threshold
Fragmentation
Threshold
Chapter 5 Wireless Configuration
DESCRIPTIONS
Select Bridge/Repeater in this field to display the screen as shown.
Set the operating frequency/channel depending on your particular region.
To manually set the ZyAIR to use a channel, select a channel from the drop-
down list box. Click MAINTENANCE and then the Channel Usage tab to open
the Channel Usage screen to make sure the channel is not already used by
another AP or independent peer-to-peer wireless network.
To have the ZyAIR automatically select a channel, click Scan instead.
Refer to the Wizard Setup
Click this button to have the ZyAIR automatically scan for and select a channel
with the least interference.
(Request To Send) The threshold (number of bytes) for enabling RTS/CTS
handshake. Data with its frame size larger than this value will perform the RTS/
CTS handshake. Setting this attribute to be larger than the maximum MSDU
(MAC service data unit) size turns off the RTS/CTS handshake. Setting this
attribute to zero turns on the RTS/CTS handshake. Enter a value between 800
and 2432.
The threshold (number of bytes) for the fragmentation boundary for directed
messages. It is the maximum data fragment size that can be sent. Enter a
value between 800 and 2432.
chapter for more information on channels.
G-3000H User's Guide
69