Layer-2 Isolation List - ZyXEL Communications NWA Seres User Manual

Figure 86 Configuration > Object > AP Profile > SSID > MAC Filter List > Add/Edit MAC Filter Profile
The following table describes the labels in this screen.
Table 61 Configuration > Object > AP Profile > SSID > MAC Filter List > Add/Edit MAC Filter Profile
LABEL
Profile Name
Filter Action
Add
Edit
Remove
#
MAC
Description
OK
Cancel

13.6 Layer-2 Isolation List

Layer-2 isolation is used to prevent wireless clients associated with your Zyxel Device from
communicating with other wireless clients, APs, computers or routers in a network.
In the following example, layer-2 isolation is enabled on the Zyxel Device to allow a guest wireless client
(A) to access the main network router (B). The router provides access to the Internet and the network
printer (C) while preventing the client from accessing other computers and servers on the network. The
client can communicate with other wireless clients only if Intra-BSS Traffic blocking is disabled.
Chapter 13 AP Profile
DESCRIPTION
Enter up to 31 alphanumeric characters for the profile name. This name is only visible in the
Web Configurator and is only for management purposes. Spaces and underscores are
allowed.
Select allow to permit the wireless client with the MAC addresses in this profile to connect to the
network through the associated SSID; select deny to block the wireless clients with the specified
MAC addresses.
Click this to add a MAC address to the profile's list.
Click this to edit the selected MAC address in the profile's list.
Click this to remove the selected MAC address from the profile's list.
This field is a sequential value, and it is not associated with a specific user.
This field specifies a MAC address associated with this profile. You can click the MAC address to
make it editable.
This field displays a description for the MAC address associated with this profile. You can click
the description to make it editable. Enter up to 60 characters, spaces and underscores
allowed.
Click OK to save your changes back to the Zyxel Device.
Click Cancel to exit this screen without saving your changes.
NWA/WAC/WAX Series User's Guide
146