Remote Management Limitations; Remote Management And Nat; System Timeout - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

24.3.5 Remote Management Limitations

Remote management over LAN or WAN will not work when:
1 A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
Web service.
2 You have disabled that service in menu 24.11.
3 The IP address in the Secured Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the ZyAIR will disconnect the session immediately.
4 There is already another remote management session of the same type (Telnet, FTP or
Web) running. You may only have one remote management session of the same type
running at one time.
5 There is a web remote management session running with a Telnet session. A Telnet
session will be disconnected if you begin a web session; it will not begin if there already
is a web session.

24.4 Remote Management and NAT

When NAT is enabled:
• Use the ZyAIR's WAN IP address when configuring from the WAN.
• Use the ZyAIR's LAN IP address when configuring from the LAN.

24.5 System Timeout

There is a system timeout of five minutes (300 seconds) for Telnet/web/FTP connections.
Your ZyAIR will automatically log you out if you do nothing in this timeout period, except
when it is continuously updating the status in menu 24.1 or when sys stdio has been
changed on the command line.
Chapter 24 System Maintenance and Information
G-3000H User's Guide
229