Ap+Bridge Mode - ZyXEL Communications ZyXEL ZyAIR G-3000H User Manual

G-3000H User's Guide
Table 15 Wireless: Bridge/Repeater
LABEL
Enable WDS Security Select the check box to enable WDS on your ZyAIR. A Wireless Distribution
#
Active
Remote Bridge MAC
Address
PSK
See Table 14 on page 65

5.6.3 AP+Bridge Mode

Click the WIRELESS link under ADVANCED. Select AP+Bridge as the Operating Mode
to display the screen as shown next. In this screen, you can configure the ZyAIR to function as
an AP and bridge simultaneously. See the section on ZyAIR applications for more
information.
70
DESCRIPTIONS
System (WDS) is a wireless connection between two or more APs.
When you select the check box, you are prompted to type a Pre-Shared Key
(PSK). The ZyAIR uses TKIP to encrypt traffic on the WDS between AP's.
Note: Other AP's must use the same encryption method to
enable WDS.
This is the index number of the bridge connection.
Select the check box to enable the bridge connection. Otherwise, clear the
check box to disable it.
Type the MAC address of the peer device in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
for information on the other labels in this screen.
Chapter 5 Wireless Configuration