Yamaha S90 ES Owner's Manual page 80

Using the S90 ES with computer software
Specific instructions for setting up your particular software follow. For instructions on how to start the software, refer to the
documentation included with the software.
Cubase SX 3
1
Pull down the [Devices] menu and select [Device
Setup] to call up the "Device Setup" window.
2
Click the [+] button and add "Mackie Control."
3
Select "Mackie Control" from the popup list.
4
When setting the Port to "4," for example, in step 4 of
"Setting up for Remote Control," set the MIDI Input to
"YAMAHA USB IN 0 - 4" and the MIDI Output to
"YAMAHA USB OUT 0 - 4."
n
The functions of buttons on the Mackie Control are assigned to the
buttons of the S90 ES, with the exception of UserA and UserB
(FootSw) which are not supported by the S90 ES.
SONAR 4
1
Pull down the [Options] menu and select [MIDI
Devices] to call up the "MIDI Devices" window.
2
When setting the Port to "4" for example in step 4 of
"Setting up for Remote Control" add "YAMAHA USB IN
0-4" to the "Inputs" and add "YAMAHA USB OUT 0 - 4"
to the "Outputs."
3
Pull down the [Options] menu and select [Control
Surfaces] to call up the Control Surface window.
4
Click the "[+] button, select "Mackie Control," then set
the Input Port to "YAMAHA USB IN 0 - 4" and the
Output Port to "YAMAHA USB OUT 0 - 4" (for example,
when setting the Port to "4" in step 4 of "Setting up for
Remote Control").
Using the Remote Control functions
1
To enter the Remote Control mode, press the [REMOTE] button (the lamp flashes).
The REMOTE display appears, and the panel controls are enabled for Remote operation of the computer software (their
normal functions are disabled).
n
Press this button again to exit from the Remote Control mode.
80
Owner's Manual
Digital Performer 4.52
1
Pull down the [Setup] menu and select [Control Surface
Setup] to call up the "Control Surface" window.
2
Click the [+] button.
3
Select "Mackie Control" in the Driver section.
4
In the box for setting "Unit" and "MIDI," select "Mackie
Control" in the "Unit" section and select the MIDI port in
the "MIDI" section.
Logic Pro 7
When turning on the power of the S90 ES before
starting Logic:
1
Start Logic on the computer, then turn on the power of
the S90 ES.
2
Start Logic on the computer.
Logic automatically recognizes the S90 ES as Logic
Control and performs the required settings.
When starting Logic before turning on the power of the
S90 ES:
1
Start Logic on the computer, then turn the power to the
S90 ES on.
If you have already set the software to be controlled to
"Logic" in the Utility mode, you need not perform step 2
because Logic automatically recognizes the S90 ES
when this step is performed.
2
Set the software to be controlled to "Logic" in the Utility
mode, then enter the Remote Control mode.
Logic automatically recognizes the S90 ES and
performs the required settings.
EFFECT
REMOTE ARPEGGIO
BYPASS