Yamaha S90 ES Owner's Manual page 144

Voice Edit mode Plug-in Voice Edit
AMod
(Amplitude Modulation Depth)
[SF4] AC (Assignable Control)
Src (Source)
Filter
PMod (Pitch Modulation Depth)
FMod (Filter Modulation Depth)
AMod
(Amplitude Modulation Depth)
[F6] EFFECT
Same as in Normal Voice Common Edit. See page 133.
Please note that the EL: OUT settings are not available in the [SF1] CONNECT display and the parallel setting (Insertion Connection) is not available in the
[SF1] CONNECT display.
Element Edit
[F1] OSC (Oscillator)
[SF1] WAVE
Bank
Number
[SF5] OTHER
VelocityDepth
VelocityOffset
NoteShift
[F2] PITCH
From this display you can make various time and level settings for the Pitch EG, which determine how the pitch of the Plug-in Voice changes over time.
The full names of the available parameters are shown in the chart below, as they appear in the display.
INIT
--- Attack time
TIME
Initial level ---
LEVEL
[F3] FILTER
HPFCutoff (High Pass Filter
Cutoff frequency)
144
Owner's Manual
Element Edit
Determines the depth of control that keyboard aftertouch has over amplitude modulation. The higher the
setting, the greater the depth of control.
Settings: 0 ~ 127
From this display you can assign MIDI Control Change numbers (as Src) and determine the degree to which
the assigned controllers affect the filter and the modulation effects (pitch, filter and amplitude).
Determines the MIDI Control Change number used to control the filter, PMod, FMod, and AMod.
Settings: 0 ~ 95
Determines the depth of control the Control Change numbers (set in the Src parameter above) have over the
filter cutoff frequency.
Settings: -64 ~ 0 ~ +63
Determines the depth of control the Control Change messages (set in the Src parameter above) have over
pitch modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
Determines the depth of control the Control Change messages (set in the Src parameter above) have over filter
cutoff modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
Determines the depth of control the Control Change messages (set in the Src parameter above) have over
amplitude modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
[VOICE] Plug-in Voice selection
From this display you can select the desired Board Voice used for the Element of the Plug-in voice. Keep in
mind that a Plug-in voice only has one Element.
Determines the Board Voice Bank.
Settings: These depend on the particular Plug-in board; refer to the relevant owner's manual for details.
Determines the Board Voice Number.
Settings: These depend on the particular Plug-in board; refer to the relevant owner's manual for details.
Determines the velocity sensitivity of the Plug-in Voice. For higher values, the harder you play the keyboard, the
louder the Voice becomes.
Settings: 0 ~ 127
This lets you specify an offset value for Velocity Depth (above). In other words, you can increase the relative
velocity (or level) of the Voice by a set amount—so that all the notes you play have the added velocity.
Settings: 0 ~ 127
Determines the transpose setting for the Plug-in voice, or the amount (in semitones) by which the pitch is
raised or lowered. The pitch range is two octaves, up or down.
Settings: -24 ~ 0 ~ +24
ATK DCY1 DCY2
--- ---
--- ---
Determines the Cutoff frequency for the High Pass Filter.
Settings: -64 ~ 0 ~ +63
[EDIT] Element selection
REL DEPTH
Pitch
Release
time
Release ---
level
0
Original pitch
Initial level
Release level
Attack time Release time
Key off
Time