Yamaha S90 ES Owner's Manual page 103

Using an Effect Plug-in Board
In the example explanation below, the PLG100-VH Vocal Harmony Plug-in Board is used to apply harmony effects to the
microphone sound in the Performance mode.
n
For Multi, the Effect Plug-in Board related parameters can be edited in the Multi Play mode or Multi Edit mode.
n
Please note that the Effect Plug-in Board cannot be used in the Voice mode.
After turning the power off, install the Effect
1
Plug-in Board PLG100-VH to slot 1.
See page 184 for details.
Plug the microphone to the A/D INPUT jack on
2
the rear panel.
n
A standard dynamic microphone is recommended. (The S90 ES
does not support phantom-powered condenser microphones.)
3
Turn the S90 ES power on.
Press the [PERFORM] button to enter the
Performance Play mode, select the desired
4
Performance, then set the microphone related
parameters.
For details, refer to steps 4 - 9 on page 38.
Check the status of the installed Plug-in
5
Boards in the [UTILITY]
STATUS display.
Select "PartAD" as the Part to which the Plug-
in Insertion Effect is applied in the CONNECT
6
display ([PERFORM]
CONNECT).
Move the cursor here, then select the Part.
GAIN
A / D INPUT
R L
[F6] PLUG [SF1]
[F3] EFFECT [SF1]
7
Select the Plug-in Insertion Effect Type.
Move the cursor here, then select the Part.
Set related parameters from the Plug-in Effect
8
display ([PERFORM]
[F6] EFFECT [SF3] PLG-EF).
For details, refer to the Owner's Manual of the PLG100-VH.
Sing or talk into the microphone to check the
9
effect sound, and adjust the settings as
necessary.
If desired, store the settings for the
microphone sound and PLG100-VH as a
10
Performance in the Performance Store mode
(page 56).
Using the Plug-in Boards
[EDIT] [COMMON]
GAIN
A / D INPUT
R L
Owner's Manual
103