Yamaha S90 ES Owner's Manual page 37

6-3
Select the Voice you've assigned to Part 2 as you
did in steps 2 - 4 in the section "Selecting a
Normal Voice" or "Selecting a Drum Voice" (page
30).
You can select the desired Bank and Number directly by
using the [DEC/NO], [INC/YES] buttons and data dial. You
can also use the Category Search function (page 32). Here,
we'll assign a flute Voice (PRE3: C Flute) to Part 2.
Voice Bank
Voice Number
SF1 SF 2
F1 F 2 F 3
Assigns an internal Voice
to the selected Part. Part.
Assigns a Plug-in Voice to the selected Part.
(Available when a Plug-in Board has been installed.)
n
Voices of the Multi part Plug-in Board PLG100-XG cannot be
assigned to Performance Parts; they are specifically meant to be
used in the Multi mode for playback of XG song data.
7
Play the keyboard.
The Part 1 (piano Voice) and Part 2 (flute Voice) can be
played in unison.
Next, we'll divide the keyboard into two sections for each
Voice.
Dividing the keyboard into separate
sections— Split
Assign the Voice of Part 1 to the lower key
8
range.
8-1
Move the cursor to Part 1.
8-2
Press a note on the keyboard while holding down
the [SF5] LIMIT H button to set the highest note
for Part 1.
n
Note that the dark bar (at "NOTE") for Part 1 changes as the note
range is changed.
SF 3 SF 4 SF 5
INFORMATION
F 4 F 5 F 6
Deletes the Voice assignment of
the selected Part.
Part 1: Piano
Part 2: Flute
Assign the Voice of Part 2 to the higher key
9
range.
9-1
Move the cursor to Part 2.
9-2
Press a note on the keyboard while holding the
[SF4] LIMIT L button down to set the lowest note
of Part 2.
n
Note that the dark bar (at "NOTE") for Part 2 changes as the note
range is changed.
SF 4
Note Limit Low
10
Play the keyboard.
Use your left hand to play piano sounds and your right
hand to play flute sounds.
Part 1: Piano
Adjusting the Part levels and storing
the Performance
Adjust the Volume settings of Parts 1 and 2 by
11
using the Control sliders.
For details, see page 42.
Store the settings as a User Performance in
12
the Performance Store mode.
For details about the Store operation, see page 56.
n
If you are editing a program and you select a different program
without storing your edited one, all the edits you've made will be
erased.
In the section above, you learned how to assign two Voices
to two different Parts. Use same procedure to assign
Voices to Parts 3 and 4, and create a full orchestral sound
or the sound of a 3- or 4-piece band—just by using a single
S90 ES. You can also use the preset Performances as
starting points in building your own custom Voice
combinations.
Performance Play mode
SF 5
Note Limit High
Part 2: Flute
Owner's Manual
37