Yamaha S90 ES Owner's Manual page 167

[F6] PLUG
[SF1] STATUS
Plug1: - Plug3:
PolyExpand
[SF2] MIDI
DEVNO. (Device Number)
PORTNO. (Port number)
GM/XG
[SF3] NATIVE1
[SF4] NATIVE2
[SF5] NATIVE3
Utility Job mode
In this Mode, you can restore this synthesizer's User memory to the factory default settings (Factory Set). For details, see page 21.
n
Since the settings of the Plug-in Boards in the Utility mode are stored not to internal User memory but to the memory on the respective boards
themselves, the data cannot be restored with this Job.
Supplementary
Setting the default display when turning the power on
[UTILITY] [F1] GENERAL
1
Enter the desired mode and the program number you wish to call up first when turning the power on.
2
Press the [ENTER] button while holding the [STORE] button to register the mode and program number set in step 1.
3
Set the PowerOnMode parameter to "last" in the [UTILITY]
4
Press the [STORE] button to store the Utility setting made in step 3 above.
5
Turn the power off and turn the power on again to call up the mode/program number set in step 2 to the display.
Indicates the name of the Plug-in Board which has been installed to this synthesizer.
This parameter is accessible only when you have two or three identical Plug-in boards installed. The "off"
setting enables two or three boards to work separately (you can select them for two or three different Parts).
When this is set to "on," the two boards effectively function together as one board (used in a single part) —
giving you double the amount of polyphonic notes you can play at one time.
Settings: on, off
From this display you can set various MIDI-related parameters for the Plug-in board.
Determines the MIDI Device Number of the Plug-in Board. This number must match the Device Number of the
external MIDI device when transmitting/receiving bulk data, parameter changes or other system exclusive
messages.
Settings: 1~16, all, off
Determines the MIDI Port number over which the Plug-in board receives MIDI data in the multi-timbral tone
generator mode (Multi/Sequence Play). One port can be set for a Multi-part Plug-in board and two ports can be
set for a Single part Plug-in board.
Settings: off, 1~3
n
The Port number for the Effect Plug-in board (VH) is fixed to 1.
n
For information on the Plug-in board and the internal tone generator block, see page 116.
Determines whether "GM on" and "XG on" messages are recognized (on) or not (off). This parameter is
available only when a Multi-part Plug-in board has been installed to slot 3.
Settings: on, off
From this display you can set the Native System parameters of the Plug-in board installed to slots 1 - 3. For
details on the parameters, refer to the owner's manual of your particular Plug-in board.
[UTILITY]
[SF4] OTHER PowerOnMode (page 164)
[JOB]
[F1] GENERAL [SF4] OTHER display.
Utility Job mode
167
Owner's Manual