Yamaha S90 ES Owner's Manual page 79

When controlling Cubase SX via MIDI port 4
Mode A
Set the Port for remote control of the sequencer or DAW. Select your sequencer and the desired Port number. When
controlling Yamaha software, select "general."
Mode B
Set the Port for remote control of the Multi Part Editor. When controlling the Multi Part Editor, select "general." In this case, the
parameter is set to "off" because the Multi Part Editor is not used.
n
The "general" setting is for remote control of the Yamaha software. This lets you control the Multi Part Editor in Mode A, and control Yamaha sequencer
software in Mode B.
n
For details on how to operate the Editor, refer to the PDF manual included with the software.
S90 ES
Remote-control block
Tone generator block
Multi
When using the Port 1 for
internal Parts and Port2 for
PLG Parts
* In the Multi mode or Sequence Play mode, the transmit Port may be set to 2 or 3 (page 100). In this case, if you try to use Port number 2
or 3 for the remote control function, the function may not work properly because of Port conflicts.
5
Press the [ENTER] button to execute the settings.
6
Press the [STORE] button to store the settings as the system setting of Utility mode.
CAUTION
If you turn the power off without storing, the currently edited settings will be lost.
CAUTION
Never attempt to turn off the power while an "Executing..." or "Please keep power on" message is shown. Turning the power off in this state may cause
the system to freeze and prevent normal startup the next time the power is turned on, as well as resulting in the loss of all user data.
7
Start the software to be remote-controlled, and make the MIDI settings and remote control settings.
Set the Port setting for remote-control on the software, referring to the illustration in step 4.
Port 4 (Mode A)
Port 1 and 2 (Playback data from sequencer)
Port 1 (Playback data from keyboard of S90 ES)*
Using the S90 ES with computer software
Computer
Cubass SX
Project file
(Song file)
Owner's Manual
79