Ctp2000 Fxs And Fxo Interface Module Cables And Pinouts; Required Cables; Rtm Pinout Locations - Juniper CTP2000 Series Hardware Manual
Circuit to packet platforms
Hide thumbs
Also See for CTP2000 Series:
- Hardware documentation (150 pages) ,
- Quick start manual (27 pages) ,
- Upgrade (26 pages)
Table of Contents
Advertisement
CTP2000 FXS and FXO Interface Module Cables and Pinouts | 48
CTP2000 Series Console Cable Pinouts | 63
CTP2000 FXS and FXO Interface Module Cables and Pinouts
IN THIS SECTION
Required Cables | 48
RTM Pinout Locations | 48
FXS Connector Pinouts | 49
FXO Connector Pinouts | 50
Required Cables
The CTP2000 2W-FXS and 2W-FX0 interface modules require the use of double-shielded cables (copper
braid plus aluminum mylar foil) to ensure EMI Compliance.
RTM Pinout Locations
Figure 29 on page 49
shows the pinout locations for both the CTP2000 2W-FXS and 2W-FXO interface
modules.
48
Advertisement
Table of Contents
Troubleshooting
