Connecting Interface Cables To A Device - Juniper SSG 5 Serial Hardware Installation

Connecting Interface Cables to a Device

6. To install a second SSG 5 device, repeat steps 1 through 5, then continue.
Figure 6: SSG 5 Rack-mount
Power Supply Holder
7. Mount the tray on the rack with the provided screws.
8. Plug in the power supply to the power outlet.
To desk-mount an SSG 5 device, perform the following steps:
1. Attach the desktop stand to the side of the device. We recommend using the
side closest to the power adapter.
2. Place the mounted device on the desktop.
Figure 7: SSG 5 Desk-mount
3. Plug in the power adapter and connect the power supply to the power outlet.
To connect interface cables to the device, perform the following steps:
1. Have ready a length of the type of cable used by the interface.
2. Insert the cable connector into the cable connector port on the device.
3. Arrange the cable as follows to prevent it from dislodging or developing stress
points:
a. Secure the cable so that it is not supporting its own weight as it hangs to
the floor.
b. Place excess cable out of the way in a neatly coiled loop.
c. Place fasteners on the loop to help maintain its shape.
Power Supply Holder

Connecting Interface Cables to a Device

19