Juniper CTP2000 Series Hardware Manual page 124

3. Default interface—From the list of available devices, such as eth0 and eth1 (or more), enter the one to
be the default.
4. Hostname of the device.
5. IP address of the interface—Enter the IP address of the selected interface, or accept the loopback
address (127.0.0.1) by default.
6. Netmask of the IP address—Enter the netmask (such as 255.255.255.128), or accept 255.255.255.0
as the default.
7. Gateway IP address—Enter the IP address of the gateway, or accept the local address (127.0.0.1) as
the default
8. Maximum transmission unit (MTU)—Enter the MTU in bytes, or accept 1500 bytes as the default.
9. Static routes added to the default interface, if any.
10. Date and time GMT (more precisely, UTC)—Enter these separately in digits for the month, day, hour,
and minutes in Coordinated Universal Time (UTC), or accept the internal settings.
The device goes into startup mode.
For example:
...
*********** Setting up the root password ************
Changing root's password!
Changing password for user root.
New password:
Retype new password:
BAD PASSWORD: it is too short
passwd: all authentication tokens updated successfully.
************** Setting up the network ***************
Configure supported protocols:
0) IPv4 Only
1) IPv6 Only
2) IPv4 and IPv6
Please select your option (rtn for 0):
There are 4 ethernet devices available for use. The default device
is the device through which the default gateway can be accessed.
117