Ctp2000 Series Interface Modules; Ctp2000 Serial Interface Modules - Juniper CTP2000 Series Hardware Manual

CHAPTER 2

CTP2000 Series Interface Modules

IN THIS CHAPTER

CTP2000 Serial Interface Modules | 11

CTP2000 Multiservice Interface Module | 12
CTP2000 T1/E1 Interface Module | 13
CTP2000 Compression Module | 13
CTP2000 4WE&M Interface Module | 14
CTP2000 2W-FXS and 2W-FXO Interface Modules | 20
CTP2000 8P-IRIG Interface Module | 26
CTP2000 Clock Interface Modules | 27
CTP2000 PMC Module | 30
CTP2000 Serial Interface Modules
The Juniper Networks CTP2008, CTP2024, and CTP2056 Circuit to Packet platforms have up to one,
three, and seven serial interface modules, respectively. The interface modules are interchangeable between
the platforms.
The following interface modules have two 100-pin connectors similar to the connectors provided on the
CTP1004 and CTP1012 platforms. Each connector provides four ports by means of the quad cable. (See
"Cabling the CTP2000 Platform Overview" on page
CTP2000 IM-8P-Provides the standard software-configurable data interfaces, including EIA530,
EIA530A, RS-232, and V.35; 8 port.
CTP2000 IM-8P-T1-Provides the standard software-configurable data interfaces, plus a configurable
T1/E1 interface; 8 port.
CTP2000 IM-8P-V-Provides the standard software-configurable data interfaces, plus a configurable
4WTO interface; 8 port.
108.) The lowest-numbered ports start at the top right.
11