Powering On; Before You Power On The Ctp2000 Platform - Juniper CTP2000 Series Hardware Manual
Circuit to packet platforms
Hide thumbs
Also See for CTP2000 Series:
- Hardware documentation (150 pages) ,
- Quick start manual (27 pages) ,
- Upgrade (26 pages)
Table of Contents
Advertisement
CHAPTER 16
Powering On
IN THIS CHAPTER
Before You Power On the CTP2000 Platform | 115
Powering On the CTP2000 Platform | 116
Powering Off the CTP Platform | 119
Before You Power On the CTP2000 Platform
Before powering on the device, make sure you complete the following tasks. See the appropriate sections
for information about these tasks.
WARNING:
you perform the installation tasks.
Installing a CTP Interface Module, Processor Module, or Clock Module on page 95
Cabling a CTP2000 T1/E1 Interface Module on page 111
Cabling the CTP Platform for DC Power on page 111
Setting Up Management Access on the CTP2000 Platform on page 121
RELATED DOCUMENTATION
Powering On the CTP2000 Platform | 116
Powering Off the CTP Platform | 119
Be sure the power source is turned off and the device is turned off before
115
Advertisement
Table of Contents
Troubleshooting
