Upgrading Components For Memory Upgrades; Upgrading Ctp2000 Series Components For Memory Upgrades - Juniper CTP2000 Series Hardware Manual

CHAPTER 14

Upgrading Components for Memory Upgrades

IN THIS CHAPTER

Upgrading CTP2000 Series Components for Memory Upgrades | 106

Upgrading CTP2000 Series Components for Memory Upgrades
Certain CTP2000 Series components need to be upgraded when RAM memory is increased, as required
by certain JUNOS version updates. The affected modules and other components can be:
Processor module that contains the RAM card
CompactFlash card
Rear transition module (RTM) in case of the PP310 and PP332 processors
To install a CTP module:
1. Ground yourself by using an antistatic wrist strap or other device, and connect it to one of the ESD
grounding jacks, if available, or another grounding device.
2. Choose the slot where you want to insert the module.
3. With a Phillips screwdriver, loosen the screws that secure the blank filler panel covering the empty
chassis slot, if present, and remove the filler panel.
4. Remove the module from its antistatic bag, being careful not to touch module components, pins, leads,
or solder connections.
5. Verify that the ejectors are in the open position (facing outward).
6. Guide the module into the chassis by placing it between the guides of the selected slot and pushing
the module until it stops.
The module stops sliding when the ejectors make contact with the chassis.
106