Ctp2000 Console Port Setup - Juniper CTP2000 Series Hardware Manual

other end of the RJ-45 cable connects to the DB-9 adapter from the bag labelled "p/n 720-014126".
Then, you can connect the PC's DB-9 male connector with the DB-9 adapter "p/n 720-014126".
See "CTP2000 Series Console Cable Pinouts" on page 63
PP310/PP332 and PP833 processor console cables, USB-to-DB9 cable, and DB9-to-RJ45 adapters.
Remote network console—Connect Ethernet to an Ethernet port, and run SSH from a remote network
console.
For initial access to the system, you need to physically connect your console directly to the device's RS-232
port. Through this connection you use the CLI to set an IP address on the device. After you configure the
IP address, you can access the device remotely (for example, through SSH).
RELATED DOCUMENTATION

CTP2000 Console Port Setup | 122

Using HyperTerminal with the CTP2000 Platform | 123
Connecting Directly to the CTP2000 Platform | 124
CTP2000 Platform SSH Setup | 125
CTP2000 Management Ports | 110
Required Tools, Wires, and Cables for the CTP2000 Platform | 109
CTP2000 Console Port Setup
You can connect a local serial console (PC, Macintosh, or UNIX workstation) directly to the CONSOLE
terminal port. When you connect a local serial console directly to the device, you can configure the device
without an IP address. To communicate with the device, you must have a terminal emulation program
running on your PC or Macintosh. You can use any terminal emulation program, such as HyperTerminal.
A UNIX workstation can use the emulator TIP.
You can connect a local serial console to the COM2 port on the PP310 and PP332 processors. On the
PP833 processor, a local serial console is connected using the supplied USB-to-DB9 cable (p/n 720-071594),
in which the DB-9 connector has the same pinout as a standard RS-232 DTE port. When the USB-to-DB9
cable is used in conjunction with the DB-9 adapter labelled "p/n 450-071855", the available RJ-45 console
pinout will be the same as the console connection on the RTM of PP332/PP310 processor.
Alternatively, if the DB-9 adapter from the bag labelled "p/n 720-056657" is used instead of "p/n
450-071855", the available RJ-45 console pinout will be similar to the CTP150 console port (and other
Juniper routers). To connect the PP833 processor with the DB-9 male serial port of a PC, additionally
connect a straight RJ-45 cable with the DB-9 adapter from the bag labelled "p/n 720-056657". The other
for information about the pinouts of
122