Ctp2000 Multiservice Interface Module - Juniper CTP2000 Series Hardware Manual

Figure 11: Sample Serial Interface Module
RELATED DOCUMENTATION
Cabling the CTP2000 Platform Overview | 108
CTP2000 Serial Interface Module Pinouts | 52
CTP2000 T1/E1 Interface Module | 13
CTP2000 Compression Module | 13
CTP2000 4WE&M Interface Module | 14
CTP2000 2W-FXS and 2W-FXO Interface Modules | 20
CTP2000 8P-IRIG Interface Module | 26

CTP2000 Multiservice Interface Module

The Juniper Networks CTP2000 Circuit to Packet platform optionally includes an 8-port Serial Multiservice
Interface module (CTP2000-IM-8p-MS) as shown in
Figure 12: CTP2000 Serial Multiservice Interface Module
The cable used with the Serial Multiservice Interface module is CTP-CBL-4Q.
The module can operate in the following modes:
Audio—Provides single and dual channel audio support for varying quality audio from 8-bit, 8-KHz quality
to 8-bit up to 16-bit, 48-KHz quality (CD quality).
4WTO—Provides single and dual channel audio support for 8-bit, 8-KHz quality with squelch support
for radio backhaul. In 4WTO mode, the Multiservice interface module is interoperable with 4WTO
daughter cards.
IRIG—Enables an interrange instrumentation group time code (IRIG-B) signal to be transported through
an IP network.
TDC—Provides combined time-correlated support for IRIG/NRZ data for telemetry applications.
Figure 12 on page 12.
CTP200 0 IM 8P IRIG
CTP2000 IM 8P MS
12