CHAPTER 2
Upgrading the CTP2000 Series Device to
CTPOS 7.x
Upgrading with the PP310 Upgrade Kit
Copyright © 2015, Juniper Networks, Inc.
This topic describes the following upgrade procedures. Follow proper antistatic procedures
throughout:
Power down the system through either the menu or CTPView.
1.
Remove the power cord.
2.
Remove the RTM from the chassis and remove the old CompactFlash card from the
3.
RTM. See
"Installing or Removing a CTP2000 Series CompactFlash Card" on page
Confirm that the jumper settings on the new RTM provided in the upgrade kit conform
4.
to PP310 jumper settings, as shown in
Figure 3 on page
12.
26.
11