Controls System Maintenance; Checking The Parking Brake; Adjusting The Traction Drive For Neutral - Toro Pro Sneak 365 Operator's Manual

4. Run the engine for 5 minutes and check the tension;
the tension should be between 7 to 10 mm (1/4 to 3/8
inch) under load of 98 N-m (22 ft-lb).
Controls System
Maintenance
The factory adjusts the controls before shipping the machine
However, after many hours of use, you may need to adjust
the controls.
Important: To adjust the controls properly, complete
each procedure in the order listed.

Checking the Parking Brake

Move the parking brake lever to the On position. If there is
little or no resistance, complete the following procedure:
1. Park the machine on a flat surface, lower any
attachments, stop the engine, and remove the key.
2. Put the parking brake in the Off position.
3. Rotate the handle of the parking brake lever 2 or 3
times clockwise.
4. Apply the parking brake.
•
If there was resistance, the adjustment is correct.
•
If there was little or no resistance, see an
Authorized Service Dealer.
Adjusting the Traction Drive
for Neutral
When positioned on a level surface, the machine must not
creep when the traction pedal is released. If it does creep,
adjust as follows:
1. Park the machine on a level surface, stop the engine,
and lower the cutting unit to the floor.
2. Block the tires.
3. Loosen the jam nuts on each end of the rod.
4. Adjust the middle nut depending on which way the
machine is creeping:
•
If the machine is creeping forward, turn the middle
nut counter clockwise.
•
If the machine is creeping backward, turn the
middle nut clockwise.
31