Toro Pro Sneak 365 Operator's Manual page 41

Problem
The engine loses power.
The machine does not drive.
Possible Cause
1. The engine load is excessive.
2. The crankcase oil level is incorrect.
3. The air cleaner filters are dirty.
4. There is dirt, water, stale fuel, or
incorrect fuel is in the fuel system.
5. The engine is overheating.
6. The diesel particulate filter needs
servicing.
7. The spark arrestor screen is clogged.
8. There is air in the fuel.
9. The compression is low.
10. The fuel tank vent is restricted.
11. The injection pump timing is incorrect.
12. The injection pump is damaged.
1. The parking brake is on.
2. The hydraulic fluid level is low.
3. The pump and/or wheel motor is
damaged.
4. The relief valve is damaged.
41
Corrective Action
1. Reduce the load; use lower ground
speed.
2. Fill or drain to the full mark.
3. Service the air filters.
4. Drain and flush the fuel system; add
fresh fuel.
5. Refer to troubleshooting item The
engine is overheating.
6. Contact your Authorized Service
Dealer.
7. Clean or replace the spark arrestor
screen.
8. Bleed the nozzles and check for air
leaks at fuel hose connections and
fittings between the fuel tank and
engine.
9. Contact your Authorized Service
Dealer.
10. Contact your Authorized Service
Dealer.
11. Contact your Authorized Service
Dealer.
12. Contact your Authorized Service
Dealer.
1. Release the parking brake.
2. Add hydraulic fluid to the reservoir.
3. Contact your Authorized Service
Dealer.
4. Contact your Authorized Service
Dealer.