Toro Pro Sneak 365 Operator's Manual page 33

Figure 36
1. Hydraulic-oil filter
5. Apply a thin coat hydraulic fluid to the rubber gasket
on the replacement filter.
6. Fill the hydraulic filter with clean hydraulic fluid.
7. Install the replacement hydraulic filter onto the filter
head. Tighten it clockwise until the filter contacts the
filter head, then tighten the filter an additional 3/4 turn.
8. Clean up any spilled fluid.
9. Start the engine and let it run for about 2 minutes to
purge any air from the system.
10. Stop the engine and check for leaks.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
within a few hours by a doctor familiar with
this form of injury or gangrene may result.
• Keep your body and hands away from
pinhole leaks or nozzles that eject high
pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks, never use your hands.
Checking the Hydraulic-Fluid Level
Service Interval: Before each use or daily
Important: Always use the correct hydraulic fluid.
Unspecified fluids will damage the hydraulic system.
1. Park the machine on a level surface, and lower any
attachments.
2. Stop the engine, remove the key, and allow the engine
to cool.
3. Open the hood.
4. Clean the area around the filler neck of the hydraulic
tank.
1
5. Remove the cap from the filler neck and check the fluid
g018923
1. Filler neck
6. If the level is low, add enough fluid to raise it to the
7. Install the cap on the filler neck.
8. Close the hood.
Changing the Hydraulic Fluid
Service Interval: After the first 250 hours
1. Position the machine on a level surface.
2. Remove the upper left panel of the console (Figure 38).
33
CAUTION
During regeneration, the diesel particulate
filter becomes extremely hot and can cause
serious burns.
Keep your body and hands away from the
engine during regeneration.
level on the dipstick (Figure 37).
The fluid level should be between the marks on the
dipstick.
Figure 37
proper level.
Every 1,000 hours/Yearly (whichever comes first)
2. Dipstick