Premaintenance Procedures; Opening The Hood; Lubrication; Greasing The Machine - Toro Pro Sneak 365 Operator's Manual

Maintenance Service
Interval
Every 1,000 hours
Every 1,500 hours
Every 2,000 hours
Every 3,000 hours
Every 4,000 hours
Monthly
Yearly or before storage
Premaintenance
Procedures
Before opening any of the covers, stop the engine and remove
the key. Allow the engine to cool before opening any covers.

Opening the Hood

Pull the rubber hood latch (on each side of the hood) from
the hood bracket (Figure 17) and open the hood.
Figure 17
1. Hood latches
Maintenance Procedure
• Change the transmission oil.
• Change the engine coolant (See an Authorized Service Dealer).
• Check the alternator drive belt tension.
• Replace the hydraulic filter.
• Change the hydraulic fluid.
• Replace all moving hydraulic hoses.
• Replace the fuel lines and connections.
• Clean or replace the diesel particulate filter.
• Replace the alternator drive belt.
• Clean the directional controls linkage assembly.
• Change the engine oil and filter.
• Drain and clean the fuel tank.
• Touch up chipped paint.

Lubrication

Greasing the Machine

Service Interval: Before each use or daily (Grease
immediately after every washing).
Grease Type: General-purpose grease.
1. Clean the grease fittings with a rag.
2. Connect a grease gun to each fitting (Figure 18, Figure
19, and Figure 20.
21
g021987
Figure 18