Toro Pro Sneak 365 Operator's Manual page 17

Note: Do not start the plow vibration until the blade
tip has entered the ground.
6. Move the vibratory-plow lever to start the plow
vibration.
7. Slowly lower the plow blade into the ground as the
machine moves forward.
8. Use the creep control lever to control the direction and
speed of the machine during plowing. The machine will
move in the same direction that you move the lever.
Note: The more you push the lever from the Neutral
position, the faster the machine will travel. The lever
will stay in this position when you release the lever.
Move the lever to the Neutral position to stop the
machine travel.
9. Use the direction or creep control levers to steer the
machine to the left or right.
Important: Do not reverse the machine with the
plow blade in the ground.
Important: Slowly lift the plow blade out of the
ground as the machine moves forward.
Note: Decrease the machine speed if the tires slip
or the blade raises out of the ground during plow
operation.
10. Reduce the speed of the machine and pull the
vibratory-plow lever to stop the plow vibration before
raising the blade out of the ground.
Changing the Plow Blade
The plow blades are heavy; use 2 people to complete this
procedure.
1. Park the machine on a level surface, lower any
attachments, and stop the engine.
Note: Ensure that the vibratory plow is raised high
enough for the blade to be changed.
2. Flip the 2 circular snap rings over and remove the
snap-ring pin (Figure 11).
1. Snap-ring pin
3. Pull the 2 pins out of the blade.
Note: The plow blades are heavy. Make sure that 1
person is holding the blade while the other person is
removing the pins.
4. Place the new blade into the plow blade assembly and
secure it with 2 pins and 2 snap-ring pins.
Removing and Installing the Skid Shoes
1. Raise the plow about 91 cm (36 inches) off the ground.
2. Stop the engine and remove the key.
3. Remove the 4 bolts, 4 nuts, and 8 washers from the
skid shoes (Figure 12).
g021986
1. Nut
2. Washer
3. Skid shoes
4. Install the new skid shoes and secure them with the
previously removed hardware (Figure 12).
17
Figure 11
2. Pin
1
2
3
4
5
Figure 12
4. Washer
5. Bolt
G025774