Transporting The Machine - Toro Pro Sneak 365 Operator's Manual

Transporting the Machine

Loading the Machine
Important: Ensure that the trailer and ramp can
support both your weight plus the weight of the machine
with any attachments.
1. Start the engine.
2. Move the attachments to transport position.
3. Secure the trailer hitch to your vehicle and put a block
at the front and rear of the trailer wheels.
4. Move the machine slowly onto the trailer.
5. Lower the attachments onto the trailer and set the
parking brake.
6. Stop the engine and remove the key.
7. Put blocks at the front and rear of each tire of the
machine.
8. Fasten the front tie-down loops of the machine to the
trailer (Figure 15).
1
Figure 15
1. Front tie-down loop
9. Fasten the rear of the machine to the trailer using
chains and a binder.
Note: Use the rear tie-down loop (Figure 16) to secure
the machine.
1. Rear tie-down loop
10. Measure the distance from the ground to the highest
point of the machine to determine the clearance height.
11. Remove the blocks from the front and rear of the
trailer wheels.
Important: After transporting the machine a few miles,
stop the truck, ensure that the tie-downs are still tight
and that the machine has not moved on the trailer.
Unloading the Machine
1. Put a block at the front and rear of the machine and
trailer wheels.
2. Remove the ties, then remove the blocks from the
machine.
g018921
3. Start the engine and release the parking brake. Refer to
Starting and Stopping the Engine (page 16).
4. Ensure that the attachments are in the transport
position.
5. Slowly move the machine off of the trailer.
19
1
g018922
Figure 16