Rotating The Wheels; Checking The Interlock System - Toro Pro Sneak 365 Operator's Manual

Rotating the Wheels

The wheels can be installed to provide a narrow or a wide
overall width of machine. Install the wheels with the deep
concave toward the machine for operation in tight areas or
the shallow concave toward the machine for wider stability.
Important: Only operate on level ground with the
narrow wheel configuration.
Tire Size Ply Rating
23 x 10.5 x 12 4
26 x 12 x 12 8
1. Park the machine on a level surface, lower any
attachments, and stop the engine.
2. Remove the rear wheels.
3. Remove the step extension from the machine (Figure
13).
4. Install the wheels on the opposite side of the machine
from which each was removed.
5. Remove the front wheels and install them on the
opposite side of the machine.
Note: Be sure to keep the tread going in the same
direction (Figure 14).
Pressure
kPa
138 20
207 30
g022223
Figure 13
psi
g023499

Checking the Interlock System

Before using the machine, make the following interlock
system checks. If any of these checks fails, contact your
Authorized Service Dealer for more information.
•
The engine should start with the traction control lever in
the Neutral position and the parking brake engaged.
•
The engine should start with the traction control lever in
the Neutral position and the operator in the seat.
•
The engine should not crank with the traction control
lever out of the Neutral position and the operator in seat
and/or the parking brake engaged.
•
The engine should kill if the traction control lever is
moved out of the Neutral position with the engine
running and the parking brake set.
•
The engine must kill if the traction control lever is moved
out of the Neutral position with the engine running and
the operator is not in the seat.
•
The engine must kill if the vibratory plow is engaged with
the engine running and operator not in the seat.
•
The engine must stop in approximately 1 second if the
operator leaves the seated position with the vibratory
plow engaged and/or directional control lever out of the
Neutral position.
18
Figure 14