Cooling System Maintenance; Servicing The Cooling System - Toro Pro Sneak 365 Operator's Manual

Note: The oil level should be even with the bottom
of the fill plug hole.
4. Add oil to raise the oil level up to the bottom of the
fill plug hole.
5. Install the fill plug.
6. Repeat for the other differential.
Changing the Axle Oil
1. Place a drain pan under the pinion housing of the axle.
2. Park the machine on a level surface, lower any
attachments, and stop the engine.
3. Remove the bolts securing the cover, and remove the
cover and gasket.
1
2
Figure 31
1. Cover
4. Clean the surfaces and install a new gasket.
5. Install the cover and drain plug.
6. Remove the fill plug.
7. Fill with differential oil until the oil is level with the
bottom of the fill plug hole.
8. Install the fill plug.
9. Repeat the procedure for the other differential.
g026668
2. Drain pan
Cooling System
Maintenance

Servicing the Cooling System

Service Interval: Before each use or daily—Check and refill
the engine coolant.
Every 100 hours—Check the cooling system hoses.
Every 250 hours—Clean the radiator.
Every 1,000 hours/Yearly (whichever comes
first)—Change the engine coolant (See an Authorized
Service Dealer).
Coolant specification: a mixture of 50% ethylene glycol
and 50% water
Engine and Radiator coolant capacity: 10.2 L (10.8 qt)
DANGER
If the engine has been running, the pressurized, hot
coolant can escape and cause severe burns.
• Do not remove the radiator cap when the engine
is hot. Always allow the engine to cool at least
15 minutes or until the radiator cap is cool
enough to touch without burning your hand
before removing the radiator cap.
• Do not touch radiator and surrounding parts
that are hot.
• Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
DANGER
Rotating shaft and fan can cause personal injury.
• Do not operate the machine without the covers
in place.
• Keep fingers, hands and clothing clear of
rotating fan and drive shaft.
• Shut off the engine and remove the ignition key
before performing maintenance.
CAUTION
Swallowing engine coolant can cause poisoning.
• Do not swallow engine coolant.
• Keep out of reach from children and pets.
29