Checking The Tires And Lug Nuts; Controls System Maintenance; Brake Maintenance - Toro MB-1600 Operator's Manual

Checking the Tires and Lug
Nuts
Service Interval: Every 40 hours—Check the
condition of the tires.
Every 40 hours—Check the lug nuts.
•
Inspect tires for cuts, slashes, or bulges. Tires with
defects need to be replaced or repaired for proper
handling and safety.
•
Check weekly to make sure all lug nuts are tight.
Torque the lug nuts to 122 N∙m (90 ft-lb). This is
important on new machines or newly replaced
wheels.
Controls System
Maintenance

Brake Maintenance

WARNING
If the brakes are not properly adjusted,
serious injury or death may occur.
Check your brakes daily. If you encounter any
problems with the brakes while operating the
machine, shut off the machine immediately
and take it to an Authorized Service Dealer
for repair.
Checking the Service Brake
Service Interval: Before each use or daily
1. Move the machine to a level, open area.
2. Pull the parking brake lever up to engage the
brake and start the engine
1. Engaged position
3. Set the engine throttle to the F
4. Step on the service brake pedal
27
(Figure 27).
Figure 27
2. Disengaged position
position.
AST
(Figure
g020704
28).