Fuel System Maintenance; Checking The Fuel Lines And Connections; Draining The Fuel Filter/Water Separator - Toro Pro Sneak 365 Operator's Manual

removed and replaced with a clean DPF. If the DPF is not
cleaned at the 50 g/L level, the engine will continue to run
at the de-rated 85% power level until the ash accumulation
reaches 60 g/L. When the ash level reaches 60 g/L, the
engine will de-rate to 50% power. At this time, the DPF is
fully plugged and needs to be removed and replaced with a
clean DPF; contact your Authorized Service Dealer for more
information.
Fuel System
Maintenance
DANGER
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A fire
or explosion from fuel can burn you and others and
can cause property damage.
• Use a funnel and fill the fuel tank outdoors, in
an open area, when the engine is off and is cold.
Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add fuel
to the fuel tank until the level is 25 mm (1 inch)
below the bottom of the filler neck. This empty
space in the tank allows the fuel to expand.
• Never smoke when handling fuel, and stay away
from an open flame or where fuel fumes may be
ignited by a spark.
• Store fuel in a clean, safety-approved container
and keep the cap in place.
Checking the Fuel Lines and
Connections
Service Interval: Every 400 hours/Yearly (whichever
comes first)—Check the fuel lines and
connections for deterioration, damage,
or loose connections.
Every 2,000 hours/Every 2 years (whichever comes
first)—Replace the fuel lines and connections.
Inspect the fuel lines and connections for deterioration,
damage, or loose connections. Tighten any loose connections
and contact your Authorized Service Dealer for assistance
in fixing damaged fuel lines.
Draining the Fuel Filter/Water
Separator
Service Interval: Before each use or daily—Check the fuel
filter/water separator.
Every 50 hours—Drain water and other contaminants
from the fuel filter/water separator.
1. Locate the fuel filter on the right side of the engine and
place a clean container under it.
2. Loosen the drain valve on the bottom of the filter
canister and allow the water to drain.
3. When finished, tighten the drain valve.
25