Toro Pro Sneak 365 Operator's Manual page 35

Figure 42
11. Put thread sealant on the threads of the suction screen
and install the screen, elbow, hose, and clamp.
12. Connect the electrical lead to the oil temperature
sending unit at the bottom of the reservoir.
13. Install the hose to the tank and secure the clamps.
14. Install the hydraulic tank assembly.
15. Fill the hydraulic tank with approximately 25.8 L (6.8
US gallons) of Toro premium all season hydraulic fluid
ISO VG 46.
Dispose of the used oil at a certified recycling center.
16. Install the dipstick cap.
17. Start the engine and let it run for a few minutes.
18. Stop the engine.
19. Check the hydraulic fluid level and top it off if
necessary; refer to Checking the Hydraulic-Fluid Level
(page 33).
Checking the Hydraulic Lines
Service Interval: Every 100 hours—Check the hydraulic
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected into
the skin must be surgically removed within a few
g026671
hours by a doctor familiar with this form of injury
or gangrene may result.
• Keep your body and hands away from pinhole
• Use cardboard or paper to find hydraulic leaks;
35
lines for leaks, loose fittings, kinked lines,
loose mounting supports, wear, weather,
and chemical deterioration. (Make
necessary repairs before operating.)
Every 1,500 hours/Every 2 years (whichever comes
first)—Replace all moving hydraulic hoses.
WARNING
leaks or nozzles that eject high pressure
hydraulic fluid.
never use your hands.