Belt Maintenance; Checking The Alternator Drive Belt Tension; Replacing The Drive Belt; Controls System Maintenance - Toro Pro Sneak 360 Operator's Manual

Belt Maintenance

Checking the Alternator Drive
Belt Tension
Service Interval: Every 1,000 hours
1. Push the drive belt with your thumb in the area shown
to check the tension (Figure 37).
Note: The deflection should be between 7 to 9 mm
(0.28 to 0.35 inches) under load of 10 kg (22 lb).
Note: If the deflection is less than 7 mm (0.28 inch)
or more than 9 mm (0.35 inch), adjust the tension.
1
2
3
4
Figure 37
1. Check the tension of the
belt here.
2. Pivot bolt
2. Loosen the pivot bolts.
3. Loosen the adjusting bolt.
4. Pull the alternator away from the engine to increase belt
tension or toward the engine to decrease belt tension,
then tighten the adjusting bolt.
5. Check the belt tension. If the tension is correct, tighten
the pivot bolts.

Replacing the Drive Belt

Service Interval: Every 4,000 hours—Replace the alternator
drive belt.
1. Loosen the pivot bolts, the adjusting bolt, and move the
alternator toward the engine to loosen the belt tension.
2. Remove the drive belt and install the new drive belt.
3. Adjust the belt tension.
g019025
3. Adjusting bolt
4. Pivot bolt
Controls System
Maintenance
The factory adjusts the controls before shipping the machine
However, after many hours of use, you may need to adjust
the controls.
Important: To adjust the controls properly, complete
each procedure in the order listed.

Checking the Parking Brake

Move the parking brake lever to the On position. If there is
little or no resistance, complete the following procedure:
1. Park the machine on a flat surface, lower any
attachments, stop the engine, and remove the key.
2. Put the parking brake in the Off position.
3. Rotate the handle of the parking brake lever 2 or 3
times clockwise.
4. Apply the parking brake.
•
If there was resistance, the adjustment is correct.
•
If there was little or no resistance, see an
Authorized Service Dealer.
Adjusting the Creep Control
Linkage
1. Remove the access panel from the right side of the
machine.
2. Connect a spring scale under the knob of the creep
control lever.
3. Turn the adjustment nut until the scale shows 13.61 to
22.68 kgf (30 to 50 lbf) to move the lever (Figure 38).
2
1
1. Adjustment nut
2. Creep control lever
30
3
4
g019042
Figure 38
3. Steering control pivot
4. Set-screw catch