Important: Refer to your Engine Operator's Manual for additional procedures.
Note: Looking for an Electrical Schematic or Hydraulic Schematic for your machine? Download a free copy of the schematic
by visiting www.Toro.com and searching for your machine from the Manuals link on the home page.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Premaintenance
Procedures
Before opening any of the covers, stop the engine and remove
the key. Allow the engine to cool before opening any covers.
Opening the Hood
1. Pull the rubber hood latch (on each side of the hood)
from the hood bracket (Figure 15).
1. Hood latch
2. Use the hood handle to raise the hood so that it pivots
upward on the front hinge.
3. Release the hood support rod and place it into the
support hole to hold the hood in an open position
(Figure 16).
1
1. Support hole
1
2
Figure 15
2. Hood handle
2
g018964
Figure 16
2. Support rod
Lubrication
Greasing the Machine
Service Interval: Before each use or daily (Grease
Grease Type: General-purpose grease.
1. Clean the grease fittings with a rag.
2. Connect a grease gun to each fitting (Figure 17, Figure
18, and Figure 19).
g018961
20
immediately after every washing).
g021987
Figure 17