5Th Wheel Swivel Caster (Tr, Yr And Bb); Adjusting The Height Of The 5Th Wheel Swivel Caster; Bb Front Wing (Bb); Adjusting The Front Wing - TiLite Rigid TR Series Owner's Manual

6. The clamp stops serve to mark the position of the
5th wheel so you can quickly remove the 5th wheel
and reinstall it later to the precise position.
5 Wheel Swivel Caster
th
(TR, YR and BB)
Adjusting the Height of the 5th Wheel
Swivel Caster
Tools Needed:
• 3/4" End Wrench
1. Remove the lock nut. See Figure 132.
2. Remove caster wheel assembly.
3. To raise the height of the 5th wheel, move spacers
from below the caster barrel to above it. To lower the
height, reverse this procedure. Note: Do not remove
spacers or a sloppy caster stem will result.
4. Replace lock nut on stem and tighten to achieve
desired swivel tension.
BB Front Wing
(BB)

Adjusting The Front Wing

Tools Required
• 5/32" Allen Wrench
• 3/16" Allen Wrench
1. Loosen the two Allen Screws on each frame clamp.
See Figure 133.
2. Loosen the Allen Screw on each 3/4" binder clamp.
3. Adjust the wing forward or backward to desired
position.
4. Tighten the two Allen Screws on each frame clamp.
5. Make sure the wing is not askew to the frame.
6. Slide the 3/4" binder clamps toward the frame until
they are flush with the frame tube and tighten the
Allen Screw on each 3/4" binder clamp. This will
enable you to remove the front wing and easily
reinstall it in the exact same position at a later time.
Front Anti-Tip
(TR Series, YR Series, ZR Series, Aero Z, BB and
Evo)

Removing the Front Anti-Tip

Tools Needed:
• 1/8" Allen Wrench
1. Remove the two Allen Screws.
2. Remove the front anti-tip assembly.
90
Lock Nut
Washer
Caster
Barrel
Caster
Caster
Exentions
Extemsions
Spacers
Stem
Jam Nut
Caster
Wheel
Assembly
Figure 132
5th Wheel Caster Adjustment
Frame
Clamps
Allen
Screws
3/4" Binder
Clamps
Figure 133
TiSport BB Front Wing Adjustment
Figure 134
Front Anti-Tip Configuration
TiLite ® OM000007 - Rev. B
Front
Anti-Tip
Allen
Screws