Chapter 5: Armrests; Tubular Swing Away Armrest (Tr Series, Yr Series, Zr Series, Aero Z And Evo); Adjusting The Height Of The Tubular Swing Away Armrest (Zr Series, Aero Z, Tr And Yr); Adjusting The Height Of The Tubular Swing Away Armrest (Tra, Yra And Evo) - TiLite Rigid TR Series Owner's Manual

Armrest
9 9
8 8
7 7
6 6
5 5
4 4
3 3
2 2
1 1
Armrest
Receiver
Allen
Screw
Figure 37
Figure 37
TRA/YRA /Evo Tubular Swing Away Armrest
Armrest
Figure 38
Armrest Receiver
Figure 38
ZR Series/Aero Z/TR/YR Tubular Swing Away
Armrest
Armrest
Pins
Armrest
Backrest Tube
Receiver
Allen
Screws
Backrest
Hinge
Figure 39
Height Adjustment of ZR Series/Aero Z/TR/YR Figure 56
Tubular Swing Away Armrest Receiver
TiLite ® OM000007 - Rev. B

CHAPTER 5: ARMRESTS

CHAPTER 5: ARMRESTS CHAPTER 5: ARMRESTS CHAPTER 5: ARMRESTS CHAPTER 5: ARMRESTS
Tubular Swing Away Armrest
(TR Series, YR Series, ZR Series, Aero Z
and Evo)
To swing away the armrest, lift the armrest and
rotate the armrest away from chair. See Figures 37
and 38. On the TR, YR, ZR Series and Aero Z,
make sure to lift the armrest until the armrest pins
are above the notch on the armrest receiver. See
Figure 38.
To replace the armrest, rotate the armrest back
towards the chair and gently push it down into place.
See Figures 37 and 38. On the TR, YR, ZR Series
and Aero Z, make sure the armrest pins are in the
notch on the armrest receiver. See Figure. 38.
NOTE: On all TiLite rigid wheelchairs, the swing
away armrests pivot on nylon sleeves, located inside
the armrest receiver. If the armrest does not rotate
properly, check the nylon sleeves for wear.
Adjusting the Height of the Tubular Swing
Away Armrest
(ZR Series, Aero Z, TR and YR)
Tools Needed:
Armrest Pin • 2 Flat Head Screwdrivers
1. Remove the armrest from the armrest receiver.
2. Remove both armrest pins. See Figure 39.
3. Reassemble the armrest pins in the desired
location on the armrest (in 3/4" increments).
4. Securely tighten both armrest pins in the new
location.
Armrest
5. Reinstall the armrest in the armrest receiver.
Adjusting the Height of the Tubular Swing
Away Armrest
(TRA, YRA and Evo)
Tools Needed:
• 5/16" Allen Wrench
• 7/16" Open End Wrench
Locknuts
1. Remove the armrest from the armrest receiver.
2. Remove the Allen Screw that passes through the
Seat Tube
armrest receiver. See Figure 40.
3. Reinsert the Allen Screw through the armrest
receiver at the desired location (in 1/2"
increments).
4. Securely tighten the Allen Screw in the new
location.
5. Reinstall the armrest in the armrest receiver.
41