Replacing Or Adjusting The Height - TiLite Rigid TR Series Owner's Manual

Allen
Screws
Footplate
Frame
Footplate
Clamp
Footrest
Extension
Allen
Screws
Binder
Clamp
Figure 10
TR Series/YR Series/Evo/YG Angle Adjustable
High Mount Footrest in the inverted position
Figure 11
ZR Series and Aero Z Angle Adjustable High
Mount Footrest
Allen Screws
Figure 12
ZR Series and Aero Z Angle Adjustable High
Mount Footrest with extension tubes
TiLite ® OM000007 - Rev. B
Series, YR Series, ZR Series, Aero Z, BB and Evo)" on
page 28.

Replacing or Adjusting the Height

Tools needed:
• 3/16" Allen Wrench
• Ruler
1. Loosen the Allen Screws in the two binder clamps
that secure the footrest extension to the frame. See
Figures 9 and 10. If replacing the footrest, loosen
the Allen Screws sufficiently to permit you to
completely remove both footrest extensions. If
adjusting the height of the footrest, loosen the Allen
Screws sufficiently to permit the footrest extensions
to move up and down freely within the binder
clamps. You can also raise or lower the position of
the clamp on the frame to achieve a greater range
of adjustability.
2. This Step 2 applies to the Evo and the TR with "C"
package only. For all other chairs, skip to Step 3
below. If you need to raise or lower the position of
the binder clamp on the frame in order to achieve
the necessary range of adjustability, you will need to
increase or lessen the width of the tube onto which
the footrest is clamped. To do this, loosen the Allen
Screws that secure the footplate to the footplate
clamp as though you were going to adjust the angle
of the footrest. See also Figure 7. When this clamp
is loosened, you can adjust the width of the
horizontal tubes inside the footplate clamp.
3. Place the end of a ruler on the floor and hold it
vertically against the left corner of the footrest. See
Figure 3. Adjust the left side of the footrest (or the new
Allen Screws
footrest) to the desired height (not less than 2" of
ground clearance) and tighten the Allen Screw in the
left binder clamp so the left side of the footrest cannot
change.
4. Repeat the procedure from step 3 above on the
right side of the footrest (or the new footrest).
5. If you loosened the Allen Screws described in Step
2 above, securely tighten them.
6. When both sides are set at an equal distance from
the floor, make sure all four wheels are in contact
with the floor and then fully tighten the two Allen
Screws in the binder clamps that secure the footrest
extensions to the chair frame.
Note Regarding High Mount Footrests: The Angle
Adjustable High Mount Footrests on the TR Series,
YR Series and the Evo may be clamped with the
tubes in a downward position (see Figure 9), or they
Extension Tubes
may be attached in an upward position (see Figure
10) in order to increase the range of adjustability. This
Allen Screws
adjustment is not possible with the Evo or the TR with
"C" package if your chair has a tapered frame.
29