Replacing The Camber Tube (Evo); Yg Series Camber Tubes; Adjusting The Rear Seat Height - TiLite Rigid TR Series Owner's Manual

Allen Screws
Nylock Nuts
Figure 73
Adjusting the Rear Seat Height of the YG/YGS
TiLite ® OM000007 - Rev. B
Replacing the Camber Tube
(Evo)
Tools Needed:
• 3/16" Allen Wrench
• Ruler
1. Remove the rear wheels.
2. Loosen, but do not remove, the Allen Screw that
secures the camber tube to each camber clamp.
See Figure 72.
3. Remove the camber tube.
4. Install the new camber tube, making sure the
distance from the outside edge of the adjustable
camber clamp to the end of the camber tube is
identical on each side of the chair.
5. Securely tighten both Allen Screws.
6. Reinstall the rear wheels.
7. Check the toe-in/toe-out and adjust as needed and
square the front casters as needed.

YG SERIES CAMBER TUBES

Adjusting the Rear Seat Height

Tools required
• 5/32" Allen Wrench
• 7/16" Open End Wrench
1. Remove the rear wheels.
2. Remove the eight Allen Screws (four on each side
of the chair) that secure the adjustable axle plates to
the frame. Carefully note the order in which the
various washers and nuts (and, in certain cases, the
stroller handle receptacle and/or anti-tip receptacle)
were originally installed on your chair as you will
need to reinstall all of these parts in the exact same
order in Step 4 below. See Figure 73.
Adjustable
Axle Plate 3. Reposition one adjustable axle plate to desired
height, making sure that two holes at either end of
each adjustable axle plate align with two holes in the
frame. Note that the holes in the frame are spaced
Adjustable
Camber Clamp
in 1" increments and the holes in the adjustable axle
plate are spaced in 1/2" increments, making the
height adjustable in 1/2" increments. Also note that
the adjustable axle plate is not vertically
symmetrical, providing greater flexibility in rear seat
height adjustment.
4. Reinstall the four Allen Screws that secure the
adjustable axle plate to the frame, making sure that
all washers and nuts (and, in some cases, the
stroller handle receptacle and/or anti-tip receptacle)
are reinstalled in the same order as they were
originally installed.
5. Repeat steps 3 and 4 with the adjustable axle plate
on the opposite side of the chair. Make sure the
second adjustable axle plate is mounted in exactly
the same location on the opposite side of the frame.
61