Mounting The Rear Anti-Tip Receptacle (Tr, Yr And Bb) - TiLite Rigid TR Series Owner's Manual

Camber Mount
Anti-Tip
Receptacle
Camber Tube Clamp
Allen Screws
Figure 126
Figure 126
Mounting the rear Anti-Tip Receptacle on the
TRA and the YRA
Camber
Tube Mount
Socket Head
Allen
Cap Screws
Screws
Anti-Tip
Anti-Tip
Recepticle
Receptacle
Release
Button
Figure 127
Mounting the Rear Anti-Tip Receptacle on the
TR, YR and BB
TiLite ® OM000007 - Rev. B
NOTE: Unless you ordered rear anti-tips when you
originally ordered your TiLite wheelchair, you will need
to order replacement Allen Screws when ordering rear
anti-tips.
Axle Plate
Tools Needed:
• 3/16" Allen Wrench
• 7/16" Open End Wrench
1. Remove the rear wheels and place the chair frame
on a level surface.
2. Remove the Allen Screws that secure the camber
tube clamp and the axle plate to the threaded
camber mount.
3. Align the two holes in the anti-tip receptacle with the
two holes in the camber tube clamp and with the
anti-tip receptacle positioned over the camber tube
and facing rearward. See Figure 126.
4. Insert the replacement Allen Screws through the
anti-tip receptacle, the camber tube clamp, the axle
plate and the non-threaded camber mount and into
the threaded camber mount.
5. Securely tighten.
6. Reinstall rear wheels.
Mounting the Rear Anti-Tip Receptacle
(TR, YR and BB)
WARNING
Mounting the rear anti-tip receptacle must be
performed by an authorized TiLite dealer or qualified
technician. If you ignore this Warning, you may fall, tip
over or lose control of the wheelchair and seriously
injure yourself or others or damage the wheelchair.
NOTE: Unless you ordered rear anti-tips when you
originally ordered your TiLite wheelchair, you will need
to order replacement Allen Screws when ordering rear
anti-tips. You will also need to order new camber tube
mounts and a camber tube clamp. See Figure 127.
Frame
Tools Needed:
• 3/16" Allen Wrench
1. Remove the rear wheels and place the frame on a
level surface.
2. Remove the Allen Screws that secure the camber
tube mounts to the frame.
3. Align the two holes in the anti-tip receptacle with the
two holes in the camber tube mounts, the camber
tube clamp and with the anti-tip receiver positioned
over the camber tube and facing rearward. See
Figure 127.
4. Insert the replacement Allen Screws through the
anti-tip receptacle, the non-threaded camber tube
mount and into the threaded camber tube mount.
5. Securely tighten.
6. Reinstall rear wheels.
87