Padded Black Nylon Back Upholstery (Bb); Tension Adjustable By Straps Seat Sling Upholstery (Zr Series,Aero Z, Bb, Tr And Yr); Adjusting The Tension - TiLite Rigid TR Series Owner's Manual

Velcro Seat Sling Straps
Cross Tube
Camber Tube
Figure 58
Tension Adjustable by Straps Seat Sling
TiLite ® OM000007 - Rev. B
7. Adjust to the desired tautness. See "Adjusting the
Tension" on page 50.
8. Align the top of the back upholstery with the
uppermost back strap.
9. Securely velcro the back upholstery to the back
straps/backrest ears and lower the back flap back
into position in front of the rigidizer bar.
10. Replace the seat cushion.
Padded Black Nylon Back
Upholstery
(BB)
If your BB chair is equipped with Padded Black
Nylon Back Upholstery, this upholstery can be
adjusted or replaced by following the procedures set
forth under "Velcro Adjustable Back Upholstery" on
pages 49 and 50.
Tension Adjustable By Straps
Seat Sling Upholstery
(ZR Series, Aero Z, BB, TR and YR)
WARNING
Do not make the seat sling upholstery tension so
loose that it does not properly support your weight.
The sling should never be so loose that the sling
causes your weight to be borne by the cross-tube
below the seat sling. See Figure 58.

Adjusting the Tension

1. Remove the seat cushion.
2. Detach the back upholstery from the seat
upholstery (see "Velcro Adjustable Back
Upholstery" on pages 49-50 or "Tension Adjustable
by Straps Back Upholstery" on pages 50-51).
3. Carefully tip the chair back until it is resting on its
rear wheels and the backrest. Do not scratch the
backrest tube.
4. Detach one Velcro tension adjustable strap, adjust
to the desired tension and refasten the strap. See
Figures 58 and 59.
5. Repeat Step 4 for each succeeding Velcro tension
adjustable strap until you have achieved the
desired tension in each strap.
6. Place the chair onto all four wheels.
7. Reattach the back upholstery to the seat
upholstery and replace the seat cushion.
51