Standard Titanium 5Th Wheel With Single Swivel Caster (Tr, Yr And Bb); Adjusting; Quick Release Titanium 5Th Wheel With Single Swivel Caster (Tr, Yr And Bb) - TiLite Rigid TR Series Owner's Manual

Allen Screws
Allen Screw
Clamp
Figure 130
Standard Titanium 5th Wheel Anti-Tip with Swivel
Caster Adjustment
Binder Bolts
Binder Bolt
Skewer Nut
Quick Release
Quick Release
Clamps
Clamp
Allen Head
Allen Head
Screws
Screw
Clamp Stops
Clamp Stop
Skewer Handle
Figure 131
Quick Release Titanium 5th Wheel Anti-Tip With
Swivel Caster Adjustment
TiLite ® OM000007 - Rev. B
Tools Needed:
• 5/32" Allen Wrench
• 7/16" Open End Wrench
1. Remove the rear wheels and place the frame on a
level surface.
2. Remove the two Allen Screws that secure the
adjustable axle plate at the rear of the frame.
Carefully note the placement of the plate and the
order of the various washers and nuts (and, if
applicable, stroller handle and/or armrest receivers).
See Figure 129.
3. Install the anti-tip receptacle as shown in Figure
129.
4. Insert the replacement Allen Screws through the
anti-tip receptacle, the axle plate, the various
washers and the locknuts and securely tighten the
locknuts.
5. Reinstall the rear wheels.
Standard Titanium 5th Wheel
With Single Swivel Caster
(TR, YR and BB)

Adjusting

Tools Needed:
• 3/16" Allen Wrench
1. Loosen the Allen Screws on each clamp. See
Figure 130.
2. Adjust the anti-tip forward or backward. Make sure
the 5th wheel is centered relative to the frame.
3. Tighten the Allen Screws.
Quick Release Titanium 5th
Wheel With Single Swivel Caster
(TR, YR and BB)
Adjusting
Tools Needed:
• 5/32" Allen Wrench
1. Lift up on the skewer handles of the quick-release
clamps and turn counter-clockwise while holding the
skewer nuts in place to permit the 5th wheel to slide
in or out of the frame. See Figure 131.
2. Loosen the Allen Screws on the clamp stops on the
3/4" Tube
3/4" tube.
3. Adjust the anti-tip forward or backward to desired
position.
4. Rotate the skewer handle of the quick release
clamps clockwise while holding the skewer nut in
place and engage the quick release clamps to
secure the 5th wheel anti-tip.
5. Slide the clamp stops along the 3/4" tube until they
are flush with the frame and tighten the Allen
Screws.
89