Reversed Handle Positions 1, 2, 3; Uni-Lock With Extension Handles (Tr Series, Yg Series, Yr Series, Zr Series, Aero Z And Evo); Composite Scissor Lock (Tr Series, Yg Series, Yr Series, Zr Series, Aero Z And Evo); Adjusting The Composite Scissor Lock - TiLite Rigid TR Series Owner's Manual

Reversed Handle Positions 1, 2, 3

You can achieve three additional wheel lock handle
positions for your Uni-Lock by reversing the wheel
lock handles from the right and left Uni-Locks. To do
this, follow the procedures below.
Tools Needed:
• 1/8" Allen Wrench
• 3/8" Open End Wrench
1. Remove the two Allen Screws and nuts that secure
the wheel lock handle to the wheel lock handle base
on both the right and left Uni-locks. See Figure 96.
2. Position the wheel lock handle from the left Uni-
Lock on the right Uni-Lock in the desired position.
3. Reinstall the two Allen Screws and nuts that secure
the wheel lock handle to the wheel lock handle
base.
4. Repeat steps 2 and 3 with the wheel lock handle
from the right Uni-Lock and the left Uni-Lock.
5. Securely tighten all screws and nuts.
Uni-Lock with Extension
Handles
(TR Series, YG Series, YR Series, ZR Series, Aero Z
and Evo)
All of the adjustments set forth under "Uni-Lock" on
pages 72-74 apply to the Uni-Lock with Extension
Handles.
Composite Scissor Lock
(TR Series, YG Series, YR Series, ZR Series, Aero Z
and Evo)

Adjusting the Composite Scissor Lock

Tools Needed:
• 3/16" Allen Wrench
1. Loosen the two Allen Screws in the wheel lock
clamp. See Figure 101.
2. Adjust the position of the wheel lock clamp on the
frame so the wheel stop embeds at least 3/16" into
the tire when engaged in the locked position.
3. Securely tighten the two Allen Screws that secure
the wheel lock clamp to the frame.

Replacing the Composite Scissor Lock

Tools Needed:
• 3/16" Allen Wrench
1. Loosen the two Allen Screws that secure the wheel
lock clamp to the frame. See Figure 101.
2. Slide the old composite scissor lock out of the
clamp.
3. Slide the new composite scissor lock into the wheel
lock clamp, but do not tighten the two Allen Screws.
74
Figure 99
Reversed Handle Positions 1, 2 and 3 Locked
Figure 100
Reversed Handle Positions 1, 2 and 3 Unlocked
Allen Screws
Figure 101
Adjusting/Replacing the Composite Scissorlock
TiLite ® OM000007 - Rev. B
1
2
3
Wheel Lock Clamp