Adjusting The Depth Of The Footrest; Flip-Up Footrest (Yg Series); Replacing Or Adjusting The Height Of The Footrest - TiLite Rigid TR Series Owner's Manual

the footrest two or three times without reapplying
threadlock to these screws. If you repeatedly adjust the
angle, TiLite requires that you reapply a medium strength
threadlock after every second adjustment.

Adjusting the Depth of the Footrest

Tools Needed:
• 5/32" Allen Wrench
• 7/16" End Wrench
If your flip-up footrest is depth adjustable, you can
adjust the depth as follows:
1. Remove the flat head Allen Screws and locknuts
that attach the footplate to the flip-up footrest pivot.
See Figure 16.
2. Move the footplate forward or backward to the
desired depth setting.
3. Reinstall and securely tighten the Allen Screws and
locknuts
High Mount Flip-Up Footrest;
Angle Adjustable High Mount Flip-
Up Footrest; Depth Adjustable
High Mount Flip-Up Footrest; and
Depth and Angle Adjustable High
Mount Flip-Up Footrest
(YG Series)
If you are unsure which type of High Mount Flip-Up
Footrest is installed on your YG Series chair, see Figure
17. Note: If your YGS chair has 90º hangers (see
Figure 19), see "90º Hanger Flip-Up Footrests; 90º
Hanger Depth Adjustable Flip-Up Footrests" on page 33
or "90º Hanger Depth and Angle Adjustable Flip-Up
Footrests" on pages 33-34.
Replacing or Adjusting the Height of the
Footrest
Tools Needed:
• 3/16" Allen Wrench
1. Loosen the two Allen Screws through the footrest
extension clamp that secures the high mount
footrest extension tube to the frame. See Figure 18.
2. Raise or lower the high mount footrest extension
tube to the desired height (not less than 2" of
ground clearance).
3. If replacing the entire footrest assembly, remove the
high mount footrest extension tube and flip-up
footrest assembly completely and reattach a new
high mount footrest extension tube and footrest
assembly at the desired height (not less than 2" of
ground clearance).
4. When both of the footrests on both sides of the chair
are adjusted to the desired height, securely tighten the
two Allen Screws through the extension clamp that
secures the high mount footrest extension tube to the
frame.
32
Figure 22
Figure 21
Figure 22 Figure 23
70 Degree 80 Degree
Figure 21
90 Degree
Figure 23
Figure 19
Available Hanger Options
Figure 24
Frame
Allen Screws
Footplate
Bracket
Footplate
Allen Screw
Figure 22
Figure 20
YGS 90º Hanger Flip-Up Footrest
TiLite ® OM000007 - Rev. B
Figure 24
Figure 21
Figure 23