Table of Contents
Advertisement
Frame
Allen
Footrest
Screw
Binder
Clamp
Figure 2
TR/YR/BB Titanium Footrest with Flat ABS
Cover
9
8
7
6
5
4
3
2
1
Figure 3
TR/YR/BB Titanium Footrest Height Adjustment
TiLite
®
OM000007 - Rev. B
1. See Figure 1 for the suggested location of the Safe
Tread.
2. Without removing the adhesive backing strip, position the
Safe Tread on the footrest and, if necessary, use a pen or
pencil to draw any edges that need to be trimmed.
3. Carefully cut the Safe Tread to size using scissors, knife
or razor blade.
4. Thoroughly clean and dry the footrest.
5. Peel the adhesive strip backing from the Safe Tread and
press firmly to the surface of the footrest, starting from the
center and working toward the edges of the Safe Tread,
making certain the edges are fully adhered.
Titanium Footrest with Flat ABS
Cover
(TR, YR, and BB)
Adjusting the Height of, or Replacing, the
Footrest
Tools needed:
• 3/16" Allen Wrench
• Ruler
1. Loosen the Allen Screws in the two binder clamps
that secure the footrest to the frame. See Figure 2.
If replacing the footrest, loosen the Allen Screws
sufficiently to permit you to completely remove the
old footrest and make sure to leave the plastic
footrest insert sleeve inside the frame tube. If
adjusting the height, loosen the Allen Screws
sufficiently to permit the footrest to move up and
down freely within the binder clamps.
2. If replacing the footrest, remove the old footrest and
install the new footrest into the frame.
3. Place the end of a ruler on the floor and hold it
vertically against the left corner of the footrest.
Adjust the left side of the footrest (or the new
footrest) to the desired height (not less than 2" of
ground clearance) and loosely tighten the Allen
Screw in the left binder clamp so the left side of the
footrest cannot change. See Figure 3.
9
4. Repeat the procedure from step 3 above on the
8
7
right side of the footrest (or the new footrest).
6
5. When both sides are set at an equal distance from
5
4
the floor, make sure all four (4) wheels are in contact
3
2
with the floor and then fully tighten the two Allen
1
Screws in the binder clamps that secure the footrest
to the wheelchair frame.
9
9
8
8
7
7
6
6
5
5
4
4
3
3
2
2
1
1
25
Hide quick links:
Advertisement
Table of Contents
