Replacing The Upholstery; Tilite Seat Cushion; Replacing The Foam Insert To Your Tilite Seat Cushion - TiLite Rigid TR Series Owner's Manual

Bolt-On
Seat Sling
Allen
Screws
Adjustment
Flap
Figure 58
Figure 59
Figure 61
Replacing Tension Adjustable Bolt-On Seat Sling
TiLite ® OM000007 - Rev. B

Replacing the Upholstery

Tools required:
• 1/8" Allen Wrench
1. Remove the seat cushion.
Fastening
2. Detach the back upholstery from the seat upholstery
Screws
(see "Velcro Adjustable Back Upholstery" on pages
49-50 or "Tension Adjustable by Straps Back
Upholstery" on pages 50-51).
3. Remove all Allen screws that attach the seat
upholstery to the chair frame. See Figure 61.
4. Detach the Velcro adjustment flap and remove the
bolt-on seat sling.
5. If your replacement upholstery included new
aluminum seat rails, proceed to step 6. If not,
remove the aluminum seat rails from old upholstery
and insert them into the new upholstery.
6. Place the new seat upholstery on the frame and
align the fastening holes in the upholstery and
aluminum seat rails with the holes in the seat tubes
of the frame.
7. Loosely install all the Allen screws on the side of the
seat sling where the Velcro adjustment flap is
located.
8. Install all the Allen screws on the opposite side of
the seat sling and securely tighten all Allen screws.
9. Detach the Velcro adjustment flap and adjust the
seat upholstery to the desired tension.
10. Fully tighten the Allen screws that attach the seat
upholstery to the frame. Note: this adjustment will
be much easier if someone assists you by
retightening the Allen screws while you hold the
adjustment flap at the desired tension.
11. Reattach the bottom of the back upholstery to the
seat upholstery and replace the seat cushion.

TiLite Seat Cushion

(TR Series, YG Series, YR Series, ZR Series, Aero Z,
BB and Evo)
Replacing the Foam Insert to Your TiLite
Seat Cushion
1. Lift up and remove the existing seat cushion from
the seat upholstery.
2. Unzip the seat cushion cover and remove the foam
insert.
3. Insert the new foam insert into the seat cushion
cover.
4. Close the seat cushion cover and replace on the
chair.
For seat cushions manufactured by manufacturers
other than TiLite (e.g. Corbee, StimuLite, Roho),
consult the owner's manual provided by the applicable
manufacturer.
53