Adjusting The Depth Of The Footrest; Swing-Away Hangers (Ygs); To Replace The Hanger On Frame - TiLite Rigid TR Series Owner's Manual

1. Remove the Allen Screw that secures the angle
adjustable footrest bracket to the frame. See Figure
22. Make sure to note the order in which you
remove the various washers and nuts when
removing the Allen Screw.
2. Reposition the existing (or replacement) footrest
assembly to the desired height (not less than 2" of
ground clearance), lining up the holes in the angle
adjustable footrest bracket with the holes in the
frame.
3. Reinsert the Allen Screw through the 1/2" washer,
the angle adjustable footrest bracket, the concave
washer, the frame, the second concave washer, the
angle adjustable footrest bracket, the second 1/2"
Figure 22
washer and the lock nut. Securely tighten.
Adjusting the Angle of the Footrest
Tools Needed:
• 5/32" Allen Wrench
• 7/16" Open End Wrench
1. Loosen the two Allen Screws and locknuts that
secure the footplate to the footplate clamp. See
Figure 22.
2. Reposition the footplate to the desired angle.
3. Securely tighten the two Allen Screws and locknuts.

Adjusting the Depth of the Footrest

Tools Needed:
• 5/32" Allen Wrench
• 7/16" Open End Wrench
1. Remove the two Allen Screws and locknuts that
secure the footplate to the footplate clamp. See
Figure 22.
2. Reposition the footplate to the desired depth.
3. Reinsert the two Allen Screws through the footplate,
the footplate clamp and the locknuts.
4. Securely tighten the two Allen Screws and locknuts.
Swing-Away Hangers
(YGS)
The swing-away hangers can be rotated inward or
outward to be removed or positioned out of the way.
To swing the hanger inward or outward, push or pull the
release lever and push the hanger inward or outward,
as desired.
To remove the hanger from the wheelchair, swing it
outward and pull it upward.

To replace the hanger on frame:

1. Align the pivot bushings with the frame front holes,
sliding in the bottom pivot first. This must be done
with the hanger slightly off center of the frame. See
Figure 23.
2. Holding the hanger (not the release lever), swing
the hanger until hanger locks in place.
34
Figure 21
Figure 23
Allen Screws
Footplate
Footplate
Clamp
Angle Adjustable
Footrest Bracket
Figure 24
Figure 22
YGS 90º Hanger Depth and Angle Adjustable
Flip-Up Footrest
Release
Lever
Frame
Front
Holes
Pivot Bushing
Figure 23
YGS Swing-Away Hangers
TiLite ® OM000007 - Rev. B
Frame
Allen Screw
Pivot
Bushing
Swing
Away
Hanger